Canadian Plastics

Hot runner nozzles for electronic parts

The new high pressure, ultra stem force Ultra 500 valve gate hot runner nozzle from Husky is designed for applications such as consumer electronics components and thin-wall technical parts that requir...

February 1, 2008   Canadian Plastics



The new high pressure, ultra stem force Ultra 500 valve gate hot runner nozzle from Husky is designed for applications such as consumer electronics components and thin-wall technical parts that require injection pressure of up to 3,000 bar (43 500 psi) in combination with tight pitch spacing.

With a bore diameter that is less than 24 mm and is able to withstand pressure up to 3,000 bar, the Ultra 500 is available for 2-to 8-drop hot runners.

The staggered stem actuation allows for sufficient stem force to produce high-quality gates for technical resins, including glass-filled materials. The independent stem actuation allows for sequential valve gate control, even with a tight pitch, allowing for cavity fill fine-tuning to achieve optimum part quality.

Husky Injection Molding Systems (Bolton, Ont.); www.husky.ca; 905-951-5000


Print this page

Related Stories

Leave a Reply

Your email address will not be published. Required fields are marked *

*